Aircraft & Site Builder:
Nate Benson
Must Visits
Other Builders
Part Suppliers
Tool Suppliers
Home Airport (KEPH)
Flight Planning
at skyvector.com
 
 Two guys, one pile of airplane parts...
Builder Hobbs
Most Recent Log Entry
Aug 5, 2010  ( Removed Floor Panels )

One of the problems with never having built an airplane, is the unknown of what lies ahead in the project. I knew there would be wiring, but really didn't know how much or what couldn't/shouldn't be routed together.

To avoid RF interference, even when dealing with shielded wire, is to keep things seperated. I want to route high voltage strobe power far away from signals travaling to and from my Dynon ADAHRS and pitch servo. Vans provides two sets of routing holes in the "center tunnel", however, I have manual pitch trim and the control cable hogs most of one route. I don't want my ADAHRS, pitch servo, possibly a transponder antenna, ELT remote, and tail nav light wires routed with both wing strobe cables. Possible RF bleed asside, I don't think everything will fit, so I need ...

Fly to the Builders Log
Current Project Status
Completion Chart

Completed: Wings, HS, VS, Rudder, and Elevators are all done minus tips. Firewall Bulkhead, Lower Portion of Tailcone.
Rolled the Canoe!!!

Finished up the fuselage riveting and rolled the canoe.

The New House
May 11, 2010  ( Boing 747-8 )

Got to see the new 747-8 Dreamliner up close and personal.

More on the new place.
 
  KitProject.com © All rights reserved. - Disclaimer